Roba Lagging Pulley

Roba lagging pulley ni lati bo kan Layer ti roba lori dada ti irin ilu nipasẹ gbona vulcanization tabi tutu imora ilana, eyi ti o ti lo lati din yiya ti awọn irin ati ki o dabobo lati fa awọn iṣẹ aye ti awọn conveyor igbanu.

Kan si Bayi PDF DOWNLOAD

Awọn alaye

Awọn afi

pulley lagging Apejuwe alaye

Awọn iru roba ti a le lo lati bo ilu naa ni: NBR, CR, HYPLON, PU, SBR, SR, ati bẹbẹ lọ. Ewo ni o le ṣe adani ni ibamu si ọja rẹ nipa lilo agbegbe ati awọn ibeere apẹrẹ ọja.

rubber lagging for conveyor pulley Ọja Awọn paramita

General rubber performance parameters as follows:

1: awọn ohun-ini ti ara ati ẹrọ ti roba dada:

Idanwo awọn nkan		Ibere	Idanwo gidi	Ipari
Agbara fifẹ MPa (Mpa)		≥18	20	tóótun
Ilọsiwaju ni isinmi (%)		≥300	317	tóótun
Eto yiyọ kuro (%) yẹ		≤25	24	tóótun
SHAW iru A Lile	Tẹ Pulley	60~70	70	tóótun
	Ọkọ ayọkẹlẹ pulley	≥70
Pipadanu Igbẹrun (mm3)		≤90	88	tóótun
aging coefficient(70℃×168h)	agbara fifẹ	-25~+25	20	tóótun
	oṣuwọn iyipada(%)
	Ilọsiwaju
	ni oṣuwọn iyipada fifọ

2: awọn ohun-ini ti ara ati ẹrọ ti roba isalẹ:

Awọn nkan Idanwo	Ibere	Idanwo gidi	Ipari
MPa ẹdọfu l e-agbara(Mpa)	≥30	30	tóótun
elongation at break(%)	≥300	330	tóótun
Agbara atako (Mpa)	≥69	80	tóótun
heat-resistance (℃)	80	85	tóótun
Adhesion strength between rubber and metal(Mpa)	≥4.0	4.9	tóótun
Adhesion strength between rubber and metal after heat treatment(Mpa) (hot air method for heat treatment，temperature 1452±2℃，time:150 minutes.)	≥3.2	5	tóótun