Pulley Lagging Rubber

Rubber lagging pulley o le ufiufi lea o se vaega o le paʻu i luga o le mata o le paʻu uamea e ala i le vevela vevela poʻo le faʻaogaina o le malulu, lea e faʻaaogaina e faʻaitiitia ai le ofuina o le uamea ma puipuia e faʻalautele le ola tautua o le fusi o le conveyor.

FESOAI NEI PDF DOWNLOAD

Fa'amatalaga

Fa'ailoga

pulley lagging Fa'amatalaga Fa'amatalaga

O ituaiga paʻu e mafai ona faʻaaogaina e ufiufi ai le paʻu: NBR, CR, HYPLON, PU, SBR, SR, ma isi. Le mea e mafai ona faʻatulagaina e tusa ai ma lau oloa e faʻaaoga ai le siosiomaga ma mea e manaʻomia mo le mamanu.

rubber lagging for conveyor pulley Oloa Parameter

General rubber performance parameters as follows:

1: mea fa'aletino ma fa'ainisinia o pa'u i luga:

Su'ega mea		Talosaga	Su'ega Moni	Fa'ai'uga
MPa mālosi-malosi (Mpa)		≥18	20	agavaa
Fa'aumi ile malepe(%)		≥300	317	agavaa
Seti tumau o toso-vavae(%)		≤25	24	agavaa
SHAW ituaiga A Malosi	Pi'o Pulley	60~70	70	agavaa
	Pulley aveta'avale	≥70
Ma'imau (mm3)		≤90	88	agavaa
aging coefficient(70℃×168h)	mālosi-malosi	-25~+25	20	agavaa
	suiga fua(%)
	Fa'aumiumi
	ile suiga ole fua faatatau

2: mea fa'aletino ma fa'ainisinia o pa'u pito i lalo:

Mea Su'ega	Talosaga	Su'ega Moni	Fa'ai'uga
MPa tete'e l e-malosi(Mpa)	≥30	30	agavaa
elongation at break(%)	≥300	330	agavaa
malosi fa'aletonu (Mpa)	≥69	80	agavaa
heat-resistance (℃)	80	85	agavaa
Adhesion strength between rubber and metal(Mpa)	≥4.0	4.9	agavaa
Adhesion strength between rubber and metal after heat treatment(Mpa) (hot air method for heat treatment，temperature 1452±2℃，time:150 minutes.)	≥3.2	5	agavaa